U7194 9r03 logging problem

stinkpalm · Post by **stinkpalm** » Mon Dec 22, 2008 1:04 pm

I will check again for the "Commanded Throttle Position" to log with the dataviewer. It must be "hidden" somewhere?!

Thx for the response, and I look forward to learning more about tuning with the predator!

Grumpy_Aero_Guy · Post by **Grumpy_Aero_Guy** » Mon Dec 22, 2008 1:05 pm

yeah, it's there...............somewhere. Next time I pull out the laptop I'll try to see where it is hidden.

stinkpalm · Post by **stinkpalm** » Mon Dec 22, 2008 2:33 pm

Looked again and couldn't find it with Dataviewer Version 3.1.8.4? Running through a U7193. I just selected the other throttle and pedal parameters that were available:

Absolute Throttle Position
Arbitrated Throttle Position
Arbitrated Accelerator Pedal Position
Accelerator Pedal Position

I logged those, and DSLogRedux was able to use one of them

My LTFT are +4.3, so Im about to adjust injector slope.

Would anyone say it's a bad idea to adjust these settings for a colder then normal air temperature? Its 37deg today when I logged the data, when usually the weather will jump up to 70-100 down here in Austin, Texas throughout the year. Should I wait until the air temperature is more average around here?

CANUCKPREDATOR · Post by **CANUCKPREDATOR** » Mon Dec 22, 2008 10:52 pm

i have a couple of tunes, winter and summer. its not hard to log a couple of times a year for seasonal temp changes.

Grumpy_Aero_Guy · Post by **Grumpy_Aero_Guy** » Mon Dec 22, 2008 11:57 pm

hey canuck... you still frequent the truck forum?

haven't noticed you over there lately... or maybe you have a different sig pic, or something...

CANUCKPREDATOR · Post by **CANUCKPREDATOR** » Tue Dec 23, 2008 12:56 am

i'm there now and then, not that much time to post stuff though.

U7194 9r03 logging problem

RE: No "Commanded Throttle Position" available in