ABU2 Lightning processor

If you have questions about custom tuning, are looking for a Powercal tuner, or want to discuss custom tuning in general, this is the place.

Moderator: mikel

Post Reply
duffee
Posts: 59
Joined: Wed Feb 21, 2007 1:46 pm

ABU2 Lightning processor

Post by duffee »

Hello,

I have a ABU2 processor in a Lightning. I am running into a situation where it will not allow a value higher than 64LB/min in the MAF curve. Is there a way around this in the software?
Top
User avatar
kmac1
Posts: 1006
Joined: Wed Mar 14, 2007 12:43 pm

RE: ABU2 Lightning processor

Post by kmac1 »

You have to ratio the injector hi and lo slope, breakpoint and displacement scalar equally to deal with this issue. For example if you install a MAFia on setting 2 you will need to multiply the above mentioned by .76 and continue to tune. Depending on the combination .76 will get you in the ballpark. If you go bigger on the maf you'll need to reduce them even more...

Kev
Kevin MacDonald
Calibration
www.jpcracing.com

For DiabloSport Tech Support: [email protected]
Top
duffee
Posts: 59
Joined: Wed Feb 21, 2007 1:46 pm

No Mafia

Post by duffee »

This truck does not have a MAFIA. I would prefer not to use one if I could find out how to get the software to take a higher value. !?
Top
User avatar
mikel
Posts: 58771
Joined: Tue Jan 16, 2007 1:17 pm
Location: DiabloSport World Headquarters
Contact:
Contact mikel

RE: No Mafia

Post by mikel »

Thats the problem, it will not let you go beyond that value.
You will need a Mafia.
Mike Litsch
DiabloSport Brand Manager
Diablo Tech support by phone:
561-908-0040
M-F 8:00 AM to 5:00 PM EST
[email protected]
Top
Post Reply

Return to “Custom Tune Support”