CalID not supported 2006 PT Cruiser

Post by **mikel** » Fri Mar 13, 2009 12:21 pm

Parnelli98 wrote:Great!

Here is the inevitable question: do you have a guess as to when the next revision will be released?

Today....

Post by **mikel** » Fri Mar 13, 2009 1:32 pm

My bad, may be a day or two to add this one, we'll know more in a bit.

Post by **mikel** » Fri Mar 13, 2009 2:34 pm

OK, looks like the new rev on the web now will work.

Parnelli98 · Post by **Parnelli98** » Fri Mar 13, 2009 3:01 pm

Mike,

E-mail sent. I'll be calling after sending the e-mail.

johan · Post by **johan** » Fri Mar 13, 2009 3:37 pm

After some more investigation on your calid we see that it is the non HO motor, it is the WKSM motor.
This motor was never supported and I am not sure if we plan on supporting it.

Parnelli98 · Post by **Parnelli98** » Sat Mar 14, 2009 11:39 pm

Mike, Johan,

I still have my Stage 1 PCM with the CalID of: 05153648AA. Would this be supported by the rev 9.17 crom that was released last Friday? If so, then I should be able to put it back on the car and use the Predator, correct?

turbofan · Post by **turbofan** » Sun Mar 15, 2009 10:32 pm

parnelli and denny (denny especially) are you guys on PT crew?

any of you guys who are looking for good info about cruisers and mods for them (especially performance mods) hit it up. www.ptcrew.com

there's a lot of info on there about the predator, and there's a TON of info about exhaust stuff like you were asking about.

johan · Post by **johan** » Mon Mar 16, 2009 9:03 am

We do not have support for that calid either, 05153648AA.
I do not think thats a stage calid, every stage calid we support for ptc and neon always begins with 45xxxx.