Diablosport Forums

how did you recover it?

I connected it back to DSdownloader and clicked on Calibration update again. Even though I had done this prior I did it again for grins. Connected it back to my truck and it gave me a different error that "update did not finish calibration update via DSDL was completed successfully, press center key to update vehicle calibration". So I click ok and let the calibration I just loaded on to the Trinity try and load onto the truck. Well it got to 100% but failed the Key on/off cycle verification, and started looping again. So I unhooked it and noticed that the [] around the Park, P symbol was back. Example [P]. So I turned the key on and heard the fuel pump this time. Then I tried starting the truck and it started up. So far everything seems fine and I drove the truck to work this morning. The only issue I have it that I still get the calibration update error and need to know how to get rid of it. I am not looking to run another calibration because I have since put my SCT custom tune back onto my truck.

I am going to use the Trinity to data log and that error keep coming and if by mistake I hit "OK" it will try to calibrate over my SCT tune . I can bypass the calibration error for the time being but I want it gone for good.

please hit reply on my email from yesterday and we will reset the tool.

garrett wrote:please hit reply on my email from yesterday and we will reset the tool.

Reply sent to email from yesterday.

Thanks

Thanks Garrett for the reset. All if well now...

Has this issue with the 2004 ram 1500 5.7 been resolved? I want to order one but don't want to have to deal with reflashing issues