Page 2 of 2
Re: Intune MAF voltage
Posted: Fri Jul 10, 2015 4:45 pm
by turbonova
log sent
Re: Intune MAF voltage
Posted: Fri Jul 10, 2015 6:47 pm
by turbonova
I already sent to CMR support. This is now a month old issue and 3 times on my dyno for something simple that should either work or a way to read MAF volts. I know I am asking for the moon here but it's kinda impossible to accurately tune the MAF curve without info
Re: Intune MAF voltage
Posted: Mon Jul 13, 2015 1:56 pm
by turbonova
Anyone???
Re: Intune MAF voltage
Posted: Mon Jul 13, 2015 2:31 pm
by mikel
turbonova wrote:Anyone???
I saw Matt replied to your email at 8:59 AM this morning telling you that the counts were working fine and explained how to get voltage from the counts.
30 minutes later, Brian replied to your email with a fix for Dataviewer to display grams per second correctly so that would not be an issue.
Since he asked you to post the log here and you referred him back to the email, I dont think he was going to come back to check this thread again.
Did you not receive any of those emails?
Thanks
Re: Intune MAF voltage
Posted: Mon Jul 13, 2015 3:05 pm
by turbonova
I did get an email saying there was an issue with the PIDs, I will try again.