Diablosport Forums

06MonteSS wrote:NICE!! so is that gonna be a software/crom update, or will it need to be sent in for a hardware update as well?

Not sure yet....

Hmmm....

I call ya.....lay your cards on the table bluffer!

mikel wrote:

sickREDsierra wrote:its almost not worth the trouble...... i would doubt the update will happen, just cause i am a doubter.

LOL, hater....its 90% done as we speak.
Last week the engineers were out datalogging my Z28....!

Any more news on the update?

SOOOO close. They thought last week was THE week, but then some little issues cropped up.

johnc wrote:SOOOO close. They thought last week was THE week, but then some little issues cropped up.

Thanks for the reply. That was fast!!

Awwww! MAN!!! I'm almost giddy with excitement!!!!

Do we have to send in the tool for HW update or is it a new firmware load???

MAN! I'll take vacation and drive my Avalanche straight on down for dyno testing, if ya want it......

Hey White... you'll have to send in the money for the upgrade (whatever that will be) and also your predator to get the hardware inside it upgraded.

then they send you back the predator with all the new goodies in it...

OK, but I still think a trip to DiabloSport sounds like a nice vacation excuse.

Just to look a few of those Diablo guys in the eye! (And maybe get them to load me up on the Dyno!!!)

hehe.. hell yeah, why not??!!

WhiteBuffalo wrote:Just to look a few of those Diablo guys in the eye! (And maybe get them to load me up on the Dyno!!!)

The typical reaction when people come on-site is "Oh my GOD! They are HORRIBLE!! Kill them, kill them with FIRE!!!"

SURE....but you haven't seen me yet!!

WB

johnc wrote:The typical reaction when people come on-site is "Oh my GOD! They are HORRIBLE!! Kill them, kill them with FIRE!!!"

AAAHAHAHAHAHAAA!!!!

I wish mine worked. I have a '04 Avalanche Z71 5.3 L gas engine and my unit lights up and that's it! No display. Nothing! I followed all the instructions like pulling fuses and setting the brake to turn off the daytime running lights and still nothing. I will be lucky to get my money back or half my money back. What a piece crap

Mine works fine. Always has, and probably always will, thanks to dedicated customer service staff and friendly users.

YIKES!!!

I know I vented a little too when I 1st started using the tool.

Chill out man!! They will get you going. Stop with all the hate spam!