Diablosport Forums

My Trinity has started acting strange. Would change screens by itself then go to a PID setup screen then bump right back to the display. Would do this every couple of minutes.

Ran the updates last week and it seems to have corrected the erratic screen, but a new problem has shown up. After engine is off and the screen goes to sleep, if truck sits overnight, the the screen will wake up, but not be able to read the pids. If I unplug the tuner, then plug back in, it goes through a cold boot and all is fine, until the next extended sleep and the whole thing repeats.

Other than the wake up problem, all seems to be fine. Any suggestions on what may be causing this?

sounds like a ghost touch, where the screen may be making contact with the case, give us a call and we'll get it swapped out, 561-908-0040

Mike, Thanx for the rapid reply.

Will get in contact later this AM.

Thanx again

Mike, Contacted tech support and they are sending out a new unit.

Thanx again