Page 1 of 1
Analog input information
Posted: Tue Oct 27, 2009 12:26 pm
by mikel
The updated manual should be coming along soon. You need a 2.5 mm stereo plug, which is DigiKey part # CP-2501SP-ND. Wire it up as follows:
To convert the slope/intercept, try the following:
low value = intercept
high value = intercept + ( 5 * slope )
I am going to sticky this thread for others.
RE: Analog input information
Posted: Tue Jul 20, 2010 1:40 pm
by aarcuda72032
seems to match the output analog from the Innovate LM1.....
Re: Analog input information
Posted: Thu Nov 25, 2010 11:07 pm
by magmax
mikel wrote:The updated manual should be coming along soon. You need a 2.5 mm stereo plug, which is DigiKey part # CP-2501SP-ND. Wire it up as follows:
To convert the slope/intercept, try the following:
low value = intercept
high value = intercept + ( 5 * slope )
I am going to sticky this thread for others.
could you elaborate more on how to convert low and high value ?
I got a 0 to 4 volt linear output from my autometer gauge, how do I
program the trinity to read an air fuel ratio instead of 0 to 4 volt reading ?