Page 1 of 1
unable to reload stock tune
Posted: Tue Jul 19, 2011 8:04 pm
by ElJay
I have a T1000 that I'm using on an 2007 Jeep Unlimited. I had to send it to you guys for a connector repair. I got it back, and tried to update the trinity. It said to return vechicle to stock. Ok, I go out, plug everything in, and I get an error message saying unable to load tune. The next page says
PCM: error unlock for reflash (-1)
Any ideas?
Thanks!
Re: unable to reload stock tune
Posted: Wed Jul 20, 2011 6:21 am
by broadfca
ElJay wrote:I have a T1000 that I'm using on an 2007 Jeep Unlimited. I had to send it to you guys for a connector repair. I got it back, and tried to update the trinity. It said to return vechicle to stock. Ok, I go out, plug everything in, and I get an error message saying unable to load tune. The next page says
PCM: error unlock for reflash (-1)
Any ideas?
Thanks!
If your original stock tune was in the Trinity when you sent it back to Diablo, I hope you were sure to tell Diablo that when you sent it in. Otherwise, they may have reset your tool after the repair. If that is the case, you will have to call Diablo with tool and your PC in hand for help with this issue.
Posted: Wed Jul 20, 2011 8:28 am
by ElJay
Hmm. I told them on the phone that I had a tune loaded in the rig but I didn't put that on the rma request. Probably should have. Hopefully they can resent the stock pcm program over email instead of me having to go to the dealer to get the pcm reflashed.
Posted: Wed Jul 20, 2011 9:44 am
by mikel
Give us a call wit the tool in the truck please...
Posted: Wed Jul 20, 2011 12:08 pm
by ElJay
Cool. I'll try and call tomorrow. If not it will be Monday. Hope that's ok.
Posted: Thu Jul 21, 2011 11:43 pm
by ElJay
Got everything reset today and the new updates installed. Thanks!
Jon