Page 1 of 1

Can get it to work

Posted: Fri Feb 23, 2007 9:29 pm
by mustangtye
I bought a used Delta chip from a friend 0ff an 01 mustang Gt. I put it in my 02 mustang Gt and the car will not idle with it, i have to stay on the gas to keep it running. Any ideas what i possibly did wrong or why it not running right. We have the same mods done to both of our cars but he is running 87 octane and i am running 93. could that make it not run?

C/A intake w/o mass air upgrade.
headers
x-pipe w/ highflow cats
flomaster catback
3.73 gears with speedo calibrater
lightweight underdrive pullies

RE: Can get it to work

Posted: Sat Feb 24, 2007 12:12 pm
by johan
You will need to have the chip burned to your specific ecu code. It will not work properly otherwise. Any Diablosport dealer with a Delta burner can do this for you.

Posted: Sat Feb 24, 2007 9:13 pm
by mustangtye
how much would a rough estimate be to reburn the chip to 93 octane to a new ecu code. also... do you get better or worse gas milage out of the chip?

Posted: Sat Feb 24, 2007 9:19 pm
by mikel
Your local dealer will set pricing. The new tune should provide a gain in mileage.

Thanks

Posted: Mon Feb 26, 2007 12:34 am
by mustangtye
how much rear wheel horsepower do you think i will get out of the chip with my mods and running 93 octane.

Posted: Thu Apr 05, 2007 1:06 am
by dieselworks1
depends on what files are available for your ecu