Diablosport Forums

while trying to enter into transmission parameters I get "exit called!" the inTune the freezes. What does this mean. I have to unplug to unfreeze it. I was trying to go from 91 CAI to modify stock tune, and need to know what axel ratio is set....I have 3.06 gears (not stock).......I cant get past this.

We are aware of this situation and we are working on it. Something got overlooked when a recent update was released. Normally this would be fixed however since it is the holidays It might take longer than expected due to the lack of staff this week.

will my car go into limp.....

need to know what to / not to do as I can't tell exactly what tune i am on

Spoke to Frank on the phone....I was able to check my parameters for the tranny (axel ratio) w/ my Predator....good thing I kept it...thanks. Let us know when you are able to fix the error w/ an update.

Any scoop on the "fix"......? Thanx, guys.

any word...also w/ viewing data logging on the tool itself?

was hoping to have it yesterday, will have it today for sure.

Not to be jerk will it be within next two hours? LOL

Here is the fix, sorry for the delay.

Mike, I did the update, I think, correctly. I still get "exit called" on the gear ratio. Also, as stated in a difefrent thread, I no longer am able to get the InTune icon on the task bar, and I get device unrecognized due to device malfunction. Also I can't get data viewer to connect w/ the tool.

please post the info.xml file from your intune drive here or email it to me.

Thanks

I have the same issue as beam. As far as the icon not showing up. Not in any hurry though Mike. You seem like you got your hands full and I plan on putting the car on the Dyno before I make any changes. I want to record any performance changes throughout all my mods.