Page 1 of 1
Question on scan tool
Posted: Thu Mar 15, 2012 10:37 am
by BBrown88
Got a question the scan tool for the intune, it says its reading two dtc's but it only shows one code. How do I look at the other one? Do I have to fix the first one, clear the codes the read it again or what? Happy with my tune on my truck but helping the family out with diagnosing their vehicles. Little confused with this.[/list]
RE: Question on scan tool
Posted: Thu Mar 15, 2012 11:39 am
by mikel
what vehicle is it?
Its possible that it is a non 'P' code, which the tool may not display.
RE: Question on scan tool
Posted: Thu Mar 15, 2012 3:04 pm
by BBrown88
it's a chrysler van. I also tried it on a chrysler pacifica and it showed the same thing only 1 code
RE: Question on scan tool
Posted: Thu Mar 15, 2012 3:10 pm
by mikel
could be using a different protocal that the vehicles we support.
RE: Question on scan tool
Posted: Thu Mar 15, 2012 3:13 pm
by Mike_Levy
inTune is CAN-Bus only, right? The older Chryslers use the ISO-Bus.
RE: Question on scan tool
Posted: Thu Mar 15, 2012 3:45 pm
by mikel
Nope, SRT4 are all SCI bus, not CAN
RE: Question on scan tool
Posted: Thu Mar 15, 2012 5:24 pm
by BBrown88
O okwell ill work around cuz its git to get fixed. I mean it only reads one code at a time. Idk I just fix one code and see how it goes from there.