Page 1 of 1
InTune Analog input logging
Posted: Wed May 02, 2012 12:20 pm
by Crazyced
Do you have any time frame for implementing the analog inputs logging directly from the Intune? This feature is the only reason I switched from my DSP and the freezing while logging with DataViewer issue is making the whole datalogging process a nightmare.
I am sure I'm not the only one eagerly waiting on this.
RE: InTune Analog input logging
Posted: Wed May 02, 2012 1:11 pm
by mikel
it is on the short list....
RE: InTune Analog input logging
Posted: Thu May 03, 2012 11:09 am
by Crazyced
Is there more PIDs available internally with the Intune then with the DSP?
RE: InTune Analog input logging
Posted: Thu May 03, 2012 11:17 am
by mikel
should be a similar list...
RE: InTune Analog input logging
Posted: Sun May 20, 2012 1:20 am
by NetNathan
I am about to purchase an Intune to also log my AFR.
I assume from this thread that the analog inputs cannot be logged.....yet? This IS going to happen?
Where is the setup screen for the analog inputs?
I assume the 0-5V input can be converted (raw to eng units) to read/display/log any analog min/max range.....like AFR?
Is there a thread where this is discussed?
What is the part number for the adapter?
.