Page 1 of 1

help! data logging reading

Posted: Thu Nov 22, 2012 7:47 pm
by clemsontigers000
This afternoon I decided to run the truck to test the knock. I have posted the recording of the knock and would like to have someone to please look at the recording and provide some feedback for the recording. At the begining of the recording, the first run was a dead stop WOT run. After that run, I u-turned and throttled hard and got the highest ST knock thus far (11.00 degree.) The next run was again from a dead stop with WOT. The remaining of the recording (about the last seven minutes or so) was just blipping the throttle on the interstate.

I did a recording earlier today just watching ST and LT knock, no RPM. During that run I got a max of 1.5 LT knock 4.0 ST knock.

Overall I am wanting to know the your interpretation of the whole run I have posted and what you believe I should do to help get the knock down or eliminated.


Thanks!

Re: help! data logging reading

Posted: Mon Nov 26, 2012 8:46 pm
by clemsontigers000
bump bump. any help?

Re: help! data logging reading

Posted: Thu Nov 29, 2012 10:27 am
by clemsontigers000
bump again!

Re: help! data logging reading

Posted: Thu Nov 29, 2012 11:59 am
by Mike_Levy
Mike is at the PRI show. I have no idea when he'll be back. Most likely Monday.

Re: help! data logging reading

Posted: Fri Nov 30, 2012 10:43 pm
by clemsontigers000
ok thanks for that info. ill bump it again next week sometime.

Re: help! data logging reading

Posted: Thu Dec 06, 2012 10:15 am
by clemsontigers000
bump bump. any help

Re: help! data logging reading

Posted: Thu Dec 06, 2012 1:16 pm
by mikel
add some fuel in the rpm range where the knock starts...