Page 1 of 1

calibration is not currently supported

Posted: Mon Jul 15, 2013 1:20 am
by hechols
Hi,
I just tried installing the Predator u7194 on my 2011 GMC YUKON 5.3 V8 flex fuel with no other aftermarket accessories on the vehicle. All stock. I rcvd the following message when try ing to install "Your Calibration is not currently supported. Predator will try and save your original backup."

So it saved my backup and then I tried updating the actual unit currently its running v.9r18 tried doing the update to the newest crom per Diablo Sport website and it said it wasn;t downgradeable??

Im hoping you can help with these 2 issues that im having.


Serial nbr on my predator 7f0045b7
Part u7194
Hardware UNIV_REV2
BUS CAN
Born 10/04/2010 18010
Bus Test PASSED

This unit has never been installed on my vehicle.

As far as my computer goes im using WIN 7 on my laptop (Asus)

Re: calibration is not currently supported

Posted: Mon Jul 15, 2013 10:22 am
by mikel
load this, then the latest update.

Re: calibration is not currently supported

Posted: Mon Jul 15, 2013 3:34 pm
by hechols
ok got it updated. Going to try it now and see if it will let me install on vehicle. How do I go about getting custom tune for my vehicle?

Re: calibration is not currently supported

Posted: Mon Jul 15, 2013 3:42 pm
by 06MonteSS

Re: calibration is not currently supported

Posted: Mon Jul 15, 2013 4:03 pm
by hechols
so how much would it cost for a custom tune for my 2011 GMC YUKON SLT ??

Re: calibration is not currently supported

Posted: Mon Jul 15, 2013 4:10 pm
by 06MonteSS
hechols wrote:so how much would it cost for a custom tune for my 2011 GMC YUKON SLT ??
if you went to my site - www.diablewtune.com - you'll see that it's only $135 USD... ;)

Re: calibration is not currently supported

Posted: Wed Jul 17, 2013 3:16 pm
by hechols
Thanks Mike for the help with updating my Predator. Great Customer Service! :D

Re: calibration is not currently supported

Posted: Wed Jul 17, 2013 5:58 pm
by mikel
No problem :)