Page 1 of 1
In Tune Calibration????
Posted: Fri May 23, 2014 7:45 pm
by dellagratti
I have a 2012 Dodge Charger SRT8 Super Bee and now an I Tune DCX. I connected to computer and it said it was updated, i checked and it has the 1r03x then below for dcx it shows 1r01. i connected to OBD2 3 times and 3 times I get:
"PCM Calibration for (VIN) might need an update. Check for Calibration Update?"
So i close screen and get "This vehicle is not supported, Contact DiabloSport."
My question is, What in the world do I need to do in order for this to work?
Re: In Tune Calibration????
Posted: Sat May 24, 2014 10:24 am
by jerseymike
From what I have read you need to go back to your PC and let the Intune update again after it has your car information. Just plug it back to the PC and it should auto update but if it doesnt you can click on the update in the intune image that pops up. It may take from 10 to 30 minutes so just let it do its thing. It took me several tries to get it updated.
Re: In Tune Calibration????
Posted: Sat May 24, 2014 2:21 pm
by dellagratti
Ive done that 3 times and and each time the Intune window opens and says "up to date" then closes and opens a web page asking me to register it, which ive done. I can never keep that window open at all. Btw when i registered it i was sent a code, what do i do with that?
Re: In Tune Calibration????
Posted: Tue May 27, 2014 11:01 am
by mikel
enter that code on the reg form to complete the process...
Re: In Tune Calibration????
Posted: Tue May 27, 2014 12:42 pm
by dellagratti
mikel wrote:enter that code on the reg form to complete the process...
Where?
