dead 2014 jeep wrangler

[zeyad aldamegh]

Hi,
just updated my trinity and i got problem.
here is the story.
i did the downgrade for the Calid and hooked up trinity to my PC and the downgrade was succeeded.
then i hooked up trinity to obd2 port start to save the original backup until it got to the end and i got message says original backup fail!!
then i tried to save the original backup aging but i got another message says THE LAST TUNE DID NOT FINISH THE ORIGINAL WILL BE RESTORED. I follow the screen and choose OK > Restore Original Backup Now > Yes ( new message says > Can't restore Original backup. It was already restored or was never saved> Continue > Just a moment and then the trinity will restart again and again,
If i hookup trinity and press the upper button on the left of the screen it takes me to the main page where i can start from beginning when i tried to save the original backup i go message says> Unable to communicate with PCM Please make sure the key is ON. DO NOT start engine. The key all ready ON position engine off. If i press Continue i got message says> Please unplug the tool and try again. i have tried several time but no luck.
this result to make my 2014 JEEP WRANGLER DEAD IT DOES NOT START ANY MORE!! TOMORROW MORNING WEDNESDAY I WILL DRIVE FROM KANSAS TO FLORIDA FOR VACATION I DON'T HAVE ANY OTHER CAR TO DRIVE IT SO PLEASE HELP ME OUT ASAP.
THANKS
Zeyad

[mikel]

please give u a call with the tool powered up in the truck, 561-908-0040x1

Thanks