Diablosport Forums

Hi.

When I try to tune my car after backup the trinity showed me this messages "please connect this trinity to the ds downloader program at your pc and click the calibration updater button to update your vehicle to a supported cal ID"
so I did plug my Trinity to PC and open DSD then my calibration was updated then back to car and it show me the same message again .. went back to PC and CAL Update one more time.. back to car.. same message!!! what to do please help.

Jeep wrangler 2014
My trinity been updated to latest Version v.1r13c

when you go back to the vehicle click Ok then keep clicking ok, and see if it eventually says a calibration update has been loaded to the tool, then it will load it to the vehicle.

Thanks Mikel, I tried holding the button No good!!

BUT, I tried took the Trinity while its connected to laptop to the car then it did update my calibration finaly

I'm having the same issue. Trinity T1000 keeps saying to "please connect this trinity to the ds downloader program at your pc and click the calibration updater button to update your vehicle to a supported cal ID"

I've done this multiple times to no success. Please help!!!!

My T1000 has been updated to v.1r13c

Keep the tuner connect to your laptop and take it to your car then update it and make sure its connected to obdII and your laptop in the same time.

Thanks Ill give it a shot. Crossing my fingers.