Diablosport Forums

Im trying to install my intune on my new 15 f150 2.7L ecoboost but im getting a calibration error after trying to update tuner. Here is a copy of info. Thanks.

Im building this today. Should have an update tomorrow.

save this update to the intune drive and let the tool import it, then you may tune the vehicle.

Thanks

Thanks, will give it a go.

installed file to intune and it updated. Went to install tuner to truck and a warning saying it may need an update comes on. Brought it into house to update and still a calibration error.

I just tried to update tuner again and it took without a calibration error. crossing fingers....

Getting the same error in truck and calibration error on PC.... BNPMBB3

the last info file is still showing the release version. did you update it after you loaded the za file?

judging by the info.xml it looks like the ITF wasn't loaded to the tool. Regardless it seems that I missed that 1 calid anyway (I apologize) and will get it rebuilt asap.

Again, sorry for delay.

Any status update? Thanks.

here you go.

before you load that file, go to settings/advanced/clear all updates, then reboot and load the update.

Cleared in tune and loaded file. I still get pcm calibration might need and update message on the intune when I plug it into truck. Thanks

thats normal, the fix was to make it work when you plug it back into the pc so it downloads the file, please try it.

Ok. Will try it on pc again.

working on trying to update it. Wont allow me to update without registering, Found a file you posted on another thread for registering the intune. didn't work