Page 1 of 1
Trying to run a calibration update
Posted: Tue Sep 08, 2015 7:21 pm
by ssprntja
I have a 2014 Ford Flex and am using the Trinity t1000. When I try to run the calibration update it tells me the following:
calibration KHDL2PJ is not supported by ford_can_gas at 1r13g. Any help for this?
Re: Trying to run a calibration update
Posted: Wed Sep 09, 2015 9:55 am
by mikel
ssprntja wrote:I have a 2014 Ford Flex and am using the Trinity t1000. When I try to run the calibration update it tells me the following:
calibration KHDL2PJ is not supported by ford_can_gas at 1r13g. Any help for this?
Please update the tool to the 1r13h version then try it again.
Thanks
Re: Trying to run a calibration update
Posted: Wed Sep 09, 2015 11:58 am
by ssprntja
Where do I find that version? When I check the downloads page I only see the g version not the h.
Re: Trying to run a calibration update
Posted: Tue Nov 03, 2015 8:34 pm
by LAFNGAS
ensure your trinity is not married, if it is then plug in the tool and go to performance and then install original backup
then go to their website and re download their dsdownloader to ensure you have the newest version.
follow the prompts and then connect the trinity to the computer with the usb cable and it should go through and auto update the tool to the newest crom and then retry installing the tune to your vehicle
Re: Trying to run a calibration update
Posted: Fri Nov 06, 2015 12:56 pm
by mike_m
LAFNGAS wrote:ensure your trinity is not married, if it is then plug in the tool and go to performance and then install original backup
then go to their website and re download their dsdownloader to ensure you have the newest version.
follow the prompts and then connect the trinity to the computer with the usb cable and it should go through and auto update the tool to the newest crom and then retry installing the tune to your vehicle
This is exactly right. Here is the complete walkthrough:
https://www.diablosport.com/images/supp ... ctions.pdf