2014 Silverado 5.3 with 3.08 gears
Posted: Mon Dec 28, 2015 2:10 pm
Hi All
I am effing frustrated with this trinity 1000 programmer from Diablo Sports. I started off by updating software and files for the programmer. Installed 87 canned tune with firm shift. I set DOD=off, speed limiter=off, set tire size and axle ratio, turned TM=On. I go for a drive and shifts 1-2=good, shifts 2-3 bangs real hard like somethings gonna break, shifts 3-4 bangs just as bad as 2-3, shifts 4-5 bang not as bad and 5-6 not to bad but still bangs. Now under part throttle all is good except 5-6 bang. Now here's the fun begins I went back into programmer and went to modify stock tune and left everything normal. Pretty much the same issues as above. Okay I say this isn't good and went back to original backup and reflashed the truck. I went for a drive and everything was back to stock. No banging at all under WOT. I figure okay lets reflash the 87 tune. I set everything as stated above except went with modify stock tune on the Transmission. I didn't change anything in the transmission settings and reflashed the truck and guess what? Effing banging again when shifting WOT. Okay gurus what the hell is going on here, I paid $800 for this programmer and my truck shifts like crap. I would be okay using 87 canned tune for the engine but would like stock TCM. I don't see any stock TCM just modify stock TCM so at this point I cant even use the 87 canned engine to just shut off DOD, speed limiter and adjust tire size without my truck banging thru the gears. I am going back to stock original until someone can sort this out as I don't feel like ruining my transmission. It also appears that this is an issue with other trucks as I have searched this entire forum and the internet. Can I please get some help with this issue or I will be sending this programmer back
. Thanks
I am effing frustrated with this trinity 1000 programmer from Diablo Sports. I started off by updating software and files for the programmer. Installed 87 canned tune with firm shift. I set DOD=off, speed limiter=off, set tire size and axle ratio, turned TM=On. I go for a drive and shifts 1-2=good, shifts 2-3 bangs real hard like somethings gonna break, shifts 3-4 bangs just as bad as 2-3, shifts 4-5 bang not as bad and 5-6 not to bad but still bangs. Now under part throttle all is good except 5-6 bang. Now here's the fun begins I went back into programmer and went to modify stock tune and left everything normal. Pretty much the same issues as above. Okay I say this isn't good and went back to original backup and reflashed the truck. I went for a drive and everything was back to stock. No banging at all under WOT. I figure okay lets reflash the 87 tune. I set everything as stated above except went with modify stock tune on the Transmission. I didn't change anything in the transmission settings and reflashed the truck and guess what? Effing banging again when shifting WOT. Okay gurus what the hell is going on here, I paid $800 for this programmer and my truck shifts like crap. I would be okay using 87 canned tune for the engine but would like stock TCM. I don't see any stock TCM just modify stock TCM so at this point I cant even use the 87 canned engine to just shut off DOD, speed limiter and adjust tire size without my truck banging thru the gears. I am going back to stock original until someone can sort this out as I don't feel like ruining my transmission. It also appears that this is an issue with other trucks as I have searched this entire forum and the internet. Can I please get some help with this issue or I will be sending this programmer back