Diablosport Forums

Hello,

The moment I got the diablo intune i2 and it was working great. Till today, when I tried to restore to original and it froze on my on final stages (axle ratio) eventhough and it just say Please Wait. Left it for more than 2 hours yet it is still not progressing. Also, during that the evic. Message of tranmission service that usually appears when writing a tune didnt appear. So i plugged it off, plugged it in again.. Tried to tune to octane 91, gave me failure and car stopped starting!

I rebooted the i2 and gave me recovery mode, did it and again stuck on axle ratio.. However car started again

Now I can't write any tunes the same message of failure then recovery mode...

What can I do?

I can't even restore it to defaults anymore..

Pump

Since the forum is being scammed.

Awaiting DS response.

Any update on this im having same issue on 2014 charger. Still havent been able to start car though

Luthius wrote:Hello,

The moment I got the diablo intune i2 and it was working great. Till today, when I tried to restore to original and it froze on my on final stages (axle ratio) eventhough and it just say Please Wait. Left it for more than 2 hours yet it is still not progressing. Also, during that the evic. Message of tranmission service that usually appears when writing a tune didnt appear. So i plugged it off, plugged it in again.. Tried to tune to octane 91, gave me failure and car stopped starting!

I rebooted the i2 and gave me recovery mode, did it and again stuck on axle ratio.. However car started again

Now I can't write any tunes the same message of failure then recovery mode...

What can I do?

I can't even restore it to defaults anymore..

Can you give us a call with the tool powered up in the vehicle during business hours?

561-908-0040x4

Thanks