Diablosport Forums

I took the car in for dealer service, so went back to stock tune. When done, tried to load 93 CAI tune but display said my car was not supported and needed an update. Hooked up to the DSDL and while updating crom it has locked (not responding). The display on the unit is lit and reads "This tool is now under remote control..." and none of the red, yellow, or green lights are doing anything. I'm not sure what to do and could use some help!

Now getting an error window.
"I did not see the tool on the selected serial port"
Hitting OK, but just keeps bringing the error window back.

it wont boot up after a reboot?
If not try holding the left directional arrow/button down while applying USB and hold it until it boots up, it should go to the vehicle selection menu.
If so leave it there and open dsdl and let it update again.

Couldn't get the DSDL to complete an update, so I unhooked it from the PC and did get to the vehicle selection menu. I chose my car and hooked back up t the OBD port, still saying:


If it makes a diffreence, the update was trying to load crom 1r13i first, stopped responding. Then 151r23e, stopped responding during the 2 times I tried updating it.
Thanks

I was able to get the update through DSDL onto my T1000, selected my vehicle and tried to load a tune again. Same issue, telling me does not support Calid.

Took a break, tried again, and just like that it's tuned up.
Not sure what I did wrong, but all is good now.