Page 1 of 1
Dynoing SRT Cherokee in 2wd
Posted: Tue Aug 26, 2008 6:41 pm
by fastlane
Can anyone share thoughts on the easiest way to do this? Can it be done through CMR? Or just pull the front shaft?
RE: Dynoing SRT Cherokee in 2wd
Posted: Tue Aug 26, 2008 7:08 pm
by Mike_Levy
Two ways that it can be done. The preferred way is to pull the front driveshaft. Its also possible to simply pull the electrical connector on the transfer case, though Chrysler warns against doing that.
RE: Dynoing SRT Cherokee in 2wd
Posted: Tue Aug 26, 2008 7:18 pm
by fastlane
I heard it could be done in the tune. Thanks for the help! About to dyno our single turbo.
RE: Dynoing SRT Cherokee in 2wd
Posted: Wed Aug 27, 2008 10:54 am
by mikel
Be sure to set it in Dyno Mode, and pull the front driveshaft....