Have them added.

Thank you for this. I wanted to make sure that This was ready to go for an event on Saturday and my Jeep is dead in the water.

Thanks again!
-Derrick

Hey Mike,

Thanks for the cal file. after I got my replacement I was able to get everything updated and squared away... I have a problem now... The T2 loaded the stock tune back (which I'm assuming is standard procedure when loading a new calibration file) The problem is, I uploaded all my custom ...

The T2 is now not even initializing. the back lights light up, but that's it. no other activity happens. I've attempted both, USB and the HDMI cable.
It's not showing the directory when plugging into a computer.
Is there a way to hard reset this?

Info.xml added

That was actually on the Superchips variant. I had that first prior to going to diablo and turned on the DRLs.. can't turn em off now

More specifically, the error message that I receive is "There are control units in this vehicle that are currently not support. and Update may be required. Please plug into a PC and run..."

I receive an error now. I pugged it in and went tune, stated that I had an unsupported powertrain module and that I needed an update. Would no longer update over wifi, so plugged it in, and then received the error as seen in the image (reads "Unsupported file for your calibration not found. Please ...

Just traded up from an I2 to a Trinity 2 Rep told me to just pull everything out of the "tunes" directory, and I'm assuming that I place them in the "tunes" directory of the Trinity 2. Is there anything more that needs to be done?

That's correct 2015 Rubicon.

I just realized that you have to ask that question cause someone with no lockers sure could say "it doesn't lockup the lockers!!" ... That's because you don't have lockers dummy..

Thanks for the heads up on the Threshold. I ask because I run around 28-30 pounds in the ...

Just wanted to see if there was any additional insights on this.

Thanks!

HI all,


Have an I2 and noticed the only thing that really works is changing the tiresize axle ratio, and enabling/disabling TPMS

I can't get Threshold to work for the life of me. at 28 psi and I have set that to 28PSI (understand the 5 above and below rule) but still throw a TPM error because the ...

Hey Thanks, Mike!

Thats a relief... now to get them to not charge a quatrillion dollars for a 3 minute flash.


Speaking of which I was reading through all the instructions and it sounds like the tuner actually updates the PCM to the latest calibration. is that the latest Chrysler cal that the ...

Question. I wanted to added Remote start to my Jeep. I have a 2015. Of course, I'll be putting the stock PCM back in to do this, however, how do I go about enabling it on the unlocked PCM? is this something that is outside of the control module ? Please let me know.

Thanks!
-Derrick

Question. I wanted to added Remote start to my Jeep. I have a 2015. Of course, I'll be putting the stock PCM back in to do this, however, how do I go about enabling it on the unlocked PCM? is this something that is outside of the control module ? Please let me know.

Thanks!
-Derrick

Question. I wanted to added Remote start to my Jeep. I have a 2015. Of course, I'll be putting the stock PCM back in to do this, however, how do I go about enabling it on the unlocked PCM? is this something that is outside of the control module ? Please let me know.

Thanks!
-Derrick