OBD Cable does not click into place

wbsrt · Post by **wbsrt** » Thu Oct 15, 2009 9:05 pm

Just received my Trinity, I must say, its Hot, but one small issue, My OBD Cable does not click securely into place. The end that clips into the Trin ? Also can i monitor the Trans Temps on my 2008 Jeep CGSRT8 ?

TIA

Mike_Levy · Post by **Mike_Levy** » Fri Oct 16, 2009 2:40 am

Force it. Its a very tight fit.

No tranny monitoring until the support the TCM.

Post by **mikel** » Fri Oct 16, 2009 8:47 am

Like Mike said, gently force it in, it WILL clip on both sides...

wbsrt · Post by **wbsrt** » Fri Oct 16, 2009 1:58 pm

Thanks Mike's I'll give it a try.

OBD Cable does not click into place

OBD Cable does not click into place

RE: OBD Cable does not click into place

RE: OBD Cable does not click into place

RE: OBD Cable does not click into place