writing tune after adjustment using trinity

[nescafe4all]

what is the best way to write the tune back to the car after adjustment ?

you know 2011+ Dodges are taking a while to install a tune, what I do is saving the tune then upload it using DSdownloader

is that how it works ?

[mikel]

using trinity?
just load the tune to the tool then flash it to the vehicle....

[nescafe4all]

it takes me almost 40 minutes to flash it to the car

also, adjustment of WOT spark and fuel don't work at all, it would be easier if it works

[mikel]

loading a tune should take less than 1 minute, its the process of reading the backup that takes 30 minutes or so....

[nescafe4all]

so how to avoid that 30 minutes each time

[06MonteSS]

it won't do it each time.. it only does it the first time you install a tune...

[DavidsChargerR/T]

Are you putting the car back to the stock tune and then loading the new tune each time. If you do that then it will take a long time. Once you have backed up the original tune and have no reason to reload it back into the car, you just can replace a Tune or Modify a Tune without ever touching the Original Stock Tune. On my car, it is like Mikel says... If I have the 91 Octane Tune in the car, then modify something in the Tune like turning off the MDS, and then load the new modified tune, it takes about a minute or so to load.

Hope it is something as simple as that which is causing you your problems. If not.. then keep speaking with the Techs.