Trouble updating Diablo Sport

[[email protected]]

Hello,

I had the Jeep in the shop last week for repairs and while it was there they reflashed the PCM. I had told them not to. I tried to reload the Diablo Sport tune and received an error message on the tuner that it needed to be updated. I connected the tuner to my computer to start the update.

It gets to the point of saying that the updates have been loaded and will restart and please be patient. The restart never happens. It locks up and never completes.

What do I need to do?

Thanks,

[mikel]

go ahead and manually reboot the device.

[[email protected]]

go ahead and manually reboot the device.

2 questions.

How do I manually reboot the device and after rebooting do I need to update again?

Thanks

[mikel]

unplug and plug it back in....no need to run the updater again.

[[email protected]]

unplug and plug it back in....no need to run the updater again.

OK - I plugged in the Tuner and opened up the inTune Updater and it automatically started the update again. Again it gets to the point where it says it will reboot automatically. I unplugged it and plugged it in again and again opened the inTune updater and again it started the update.

Am I doing something wrong?

Thanks for your help.

[mikel]

no, dont let the updater run again, reboot it and let it sit please, or plug it into the vehicle and let it sit, it should start updating.

[[email protected]]

no, dont let the updater run again, reboot it and let it sit please, or plug it into the vehicle and let it sit, it should start updating.

OK - I ran the update again and now will unplug and replug (into computer) and let it sit and see what happens.

Thanks

[[email protected]]

no, dont let the updater run again, reboot it and let it sit please, or plug it into the vehicle and let it sit, it should start updating.

I'm not sure if this is related, But when I plug into the truck I get the following error message


PCM Calibration for (VIN Number) Might need an update.Check for a calibration update?

[[email protected]]

no, dont let the updater run again, reboot it and let it sit please, or plug it into the vehicle and let it sit, it should start updating.

I unplugged and plugged in again in the computer. It goes through it's process to turn on, but did not see it update.

I have run updates in the past with no issues. Did having the dealer update the PCM screw things up?