Sonic/Cruze 1.4T now supported!

[ramon64124]

2014 chevy cruze LTZ with push start. Tried to install the tune. the first time it failed, booted me to recovery, and I was able to install the stock recovery loaded to my intune. came back in plugged it in to the laptop, and the device updated for about 45 mins, after I registered it, I went back outside and tried to install the tune again and it failed again, but this time the intune was not able to install the recovery.

For the worse part, my car will not start. tried to reinstall the tune several times with not success, disconnected the battery, nothing. please help! I need to be at work Monday.

Help will be much appreciated.

[ramon64124]

i also get this message When i run the program and try to write vehicle i get the message "PCM calibration for (vin#) might need an update. Attempt a backup read?"

Its a i-1000 model.

I also noticed that my backup tunes are located in my tunes folder on the intune, so I'm hoping I don't need my car towed away, and reflashed back to stock.

[06MonteSS]

they don't work weekends man...

You can contact Diablosport Tech Support at [email protected] or 1-561-908-0040, option 1 for tech support... Mon-Fri, 9am-6pm (EST).

[mazdaspeed1992]

it wont work on our cruze it says cannot back up factory tune after waiting almost 10 minutes to try to download then car wouldn't start until I hit install factory tune then says it didn't have it but then the car started again. its a 2012 cruze with 1.4t auto using a trinty t1000