InTune Duramax Shifting

Post here with any questions regarding the use of the i2 on supported Chevrolet, GMC, Cadillac, Buick, and Pontiac applications.

Moderator: sohfast94

Post Reply
chaffee
Posts: 7
Joined: Mon Mar 28, 2016 7:25 pm

InTune Duramax Shifting

Post by chaffee »

Hi Gents,

I have an I2030 installed on my 2002 LB7 Duramax. When running on the two economy sport tunes it runs great, except when I wide open throttle and the truck downshifts to 3rd from 4th or 5th, it will rev to redline then will not upshift again. I will stay in 3rd gear unless I shift it to neutral and then back to drive. I have not and probably will not run it on the maximum performance tune as I don't want any over torque issues, just want to offset some of the bottom end loss I experience with 5" exhaust.

When this occurs it does not throw a code or limp mode the transmission. Suggestions?
User avatar
mikel
Posts: 58735
Joined: Tue Jan 16, 2007 1:17 pm
Location: DiabloSport World Headquarters
Contact:

Re: InTune Duramax Shifting

Post by mikel »

sounds like the trans is not able to hold the extra torque, might be worth looking into a fluid/filter change or a soft part rebuild to freshen it up.
Mike Litsch
DiabloSport Brand Manager
Diablo Tech support by phone:
561-908-0040
M-F 8:00 AM to 5:00 PM EST

[email protected]
Post Reply

Return to “i2/i3 for GM vehicles”