Board index Trinity 2 T2 for Dodge/Chrysler/Jeep/Ram 2010 Charger SRT8 "Control Units not supported"?

2010 Charger SRT8 "Control Units not supported"?

This area of the forum is for discussions relating to the T2 monitor/tuner on Chrysler vehicles.

Moderator: sohfast94


We like to use the T2 to flash the magnuson tune on.
But i can even read the stock tune. As i go on Tuning Button it reads that some of the contol units are not supported, and i should update. I had done the update today, as descriptet by magnuson.
Datalogging works. Not that fast but works.

T2 is brandnew and there is no vin locked.

Some ideas?

Thank's a lot!

Posts: 56311
Location: DiabloSport World Headquarters

did you do the update after it was requested at the vehicle?
Updating before hand is always a good idea, but the vehicle is asking for an update now and you simply need to update again to get it.
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
M-F 8:00 AM to 5:00 PM EST

Return to T2 for Dodge/Chrysler/Jeep/Ram