Please help ! I don’t want to brick my PCM for the 2nd time ..

[Pplk225]

Ok so I will not try to make this a long post … but long story short I’m super stuck guys I was restoring my original tune to tweak some stuff and on applying part the tuner like had a glitch … now on the i3 platinum tuner it says “no ECUs detected” but my car is still in my log just no vin now and my car won’t crack over or do anything says press clutch in … trying to figure out my next steps what a birthday to kick it off.. thank you .


*EDIT* so I went ahead a purchased a PCM with my vin attached … here’s my question again if I plug my new PCM up ( same vin as on the tuner ) will it auto load the last time that messed it up or will it let me back my new original tune up ( the factory one ) I just don’t want to plug it in then plug my I3 Tuner in and bam this one bricked now too … I also have 2/2 license and on mines it says VIN: no vehicle found would this be because me needing to purchase a license ? I am just scared the tuner will try to auto load the last tune and corrupt it …

[mikel]

plz dont do anything with the tuner on the new pcm until you call and have it reset first.

does the new pcm work in the car already?