Diablosport Forums

im in phoenix airzona. Ive been to eveyones house i know using there computers and it just wont work. Im to the point of send it back and going with B&G like i was going to in the first place

Posting again in the hope of resolving this issue...........

Ok this is an issue most guys in Australia are having and from what I have read is an issue a few guys are having in the US.

It is the problem with the Calibration Updater. Here's the story....

I connected the tuner to my car for the 1st time and followed the instructions exactly as they were in the downloaded manual. As I progressed I was told that I needed an update as per this site before I could progress to loading any tune into my vegilce.

Not a worry. So I hook up the unit pass the connection test and all is good till this point. I am then directed to the Calibration Update page where there is a button to press named Calibration Updater.

When I press this button a new screen opens with a green progress bar that shows me what is being downloaded. Problem though, an error message comes straight up saying 'An error occured while trying to retrieve data from server. Are you connected to internet'. Yes I am (see this post... )

So this is where I am stuck and cannot use the tuner. I have had a good look and read through all instructions and can't see what else I may or may not be doing. Hope that explains exactly what I have done.

I have tried 3 machines, 1 laptop running a P3 with XP, another laptop running a P4 with XP and my desktop running Vista. On one of the laptops I have I gone as far as removing all firewalls and deleting all AV and Internet secuirty software from one of our laptops. I also directly connected to the internet via the modem after removing the router.

There is definitely an issue here. I have the latest update on the hand held, all I need now is the CALIBRATION UPDATE so I can get the tune into my car and also use the Predator.

Please help and come back with an answer. Would like to use this by the weekend. Also the supplier here in Australia has over a dozen of these that he is not going to release until it is sorted so his customers will also be hanging out for an answer.

Thanks in advance

Daniel.

Please try DSDownloader 1.9.5.3 and let us know if this helped.

Just downloaded and tried it but still no luck. My AV program did pop up asking me whether I would like to proceed, I confirmed ok but them I got the same message as before.

Ahhhh. Anything else mate.

Was there a "(code #)" in the message, where the # was some number? That number would be useful to help diagnose.

Not to sure and I cannot replicate it now. I have tried re installing it and no luck. Anything else I can do?????????

There you are that is what I got. See above post. All is now allowed

What message does DSDL give you after you click OK. That is what I need to see. There is an error code embedded in that message.

There is no error message that comes up. The only other details are here.....

These are all the screens and the only screens that ever come up. The Symantec screen only came up as I had just reinstalled it again after trying to log on without it. Just trying to eliminate any possibilities.

Thank you for the additional info. When you click Help -> About the version you see is 1.9.5.3 ?

Yes the version is 1,9,5,3

I also got something different on the screen and it looked different also.

I cannot get that message back up either.

Ok, the code 2 is what I was looking for. Stay with me for a moment, I have something else to try.

Thanks mate.