Diablosport Forums

How do I configure the trinity to read boost in psi?

in logging menu click on the boost gauge and select change display units, then save the layout with a new name and it will show up in that layout as psi.

mikel wrote:in logging menu click on the boost gauge and select change display units, then save the layout with a new name and it will show up in that layout as psi.

Thanks got that done, but it's not reading anything do I need to add an external sensor? Vortech super charger.

no...did you save the layout?

mikel wrote:no...did you save the layout?

Layout? gauge layout right? Went out and did a new layout, Boost, AFR, MAP, Intake temp F, saved and put in monitoring and the boost still doesn't work.

Guy's what else can you suggest, are there certain PID's that need to be with the boost to make it work, like a special layout?

there is a walk through in the manual, but you click on the gauge and select change display units, select pi, then when its done, click the red X in the corner and choose to save the layout with a new name.

Ok setup a layout with Boost, OBDII MAP, OBDII Baro, engine RPM I got the boost to read for a split second, then nothing.

mikel wrote:there is a walk through in the manual, but you click on the gauge and select change display units, select pi, then when its done, click the red X in the corner and choose to save the layout with a new name.

Yes I did all that

retromusclecar wrote:

mikel wrote:there is a walk through in the manual, but you click on the gauge and select change display units, select pi, then when its done, click the red X in the corner and choose to save the layout with a new name.

Yes I did all that

Do you think an update is needed?

What version is on the tool currently?

This has worked for some time now....

The trinity is not even a year old so It should be good, if you were to setup a page to read boost what pids would have to use with the boost pid in order for it to read?