DiabloSport Catch Cans RELEASED

[1FST4DR]

Hey Guys,
Received the catch can for SRT Jeep but no instructions and brackets? All I have is the can, hoses and a nut in a bag. Is that all there is? Where is the best place to mount? I saw the pictures in this post but what holds/supports the can in the install near the cold air intake tube?

Sounds like they sent you the wrong can.Shoot Mikel a PM and he can help you.

[mikel]

Thats odd, yeah, give us a call and we'll figure it out...

[SKULLBOY]

And for the 3.5L V6 guys, you can make the 5.7/6.1 Catch Can work in our cars..............you just need a little creativity and be handy with tools.........

I picked up a BT Catch Can From a Local LX'r......

Even though it is for a 5.7/6.1 Hemi, for the price I figured I could make it work in my 3.5L V6..............

Fabricated a alloy Bracket that attaches to the Front Passenger side of the motor. Ran the hose from the PCV to the catch can inlet (had to splice in roughly an additional 16" of hose), then ran hose from the can outlet down the side and around the back of the motor up to the Manifold.

Needed about 4' of 1/2 rubber hose.........

After giving the Catch Can a nice buff & polish, it got installed this afternoon......








Seems to be working perfectly!!!!

[Letxen3]

i am looking to getting a catch can. can someone tell me the length width and height of the can. thanks.

[captusha]

How needs a "catch can" installed in the car? I did't understand how it catches the oil. Is there a instuction available?

Do I need one for my Dodge Durango 08 HEMI after tuning?

[captusha]

Hello? -knock-knock-

[mikel]

It installes betweenthe PCV valve and intake manifold, and it comes with instructions.

They are not yet available for the 08 Durango.

[HemiShane]

Do you have this for the 09 Ram Hemi yet? If so, let me know how to purchase it.

[tony_phx]

Looking forward to getting mine today. I'll be installing tomorrow! : )

[300cdreams]

Thought you might like these.

http://www.shopatron.com/index/617.0.58519.0.0.0.0

What is this product like on the inside? I really like the information about the product and it's construction of the E2 Elite Engineering PCV Oil Catch Can. What is the construction of this one like and how much oil will it hold etc..?
Even when I went to the BT site it gives no information other then " The innovators of the two chambered top. Do not be fooled by cheap imitations, or copy cats." Does the Diablosport catch can, catch ALL the oil?

[Mike_Levy]

There is no construction. Its completely billet, machined into a can. This without question the best can on the market. I've run BT cans on both my SRT8s, and wouldn't even consider the inferior Elite Engineering crap.

[gump1114]

can we get a picture of where this mounts on the srt4 please? thanks!

[Weedahoe]

Are theses supposed to be higher, lower or level with the intake or does it even matter.

[IntimidatorSE]

well, I got mine from BT and it is for the 3.5L. took about 3 minutes to install. and it works pretty good too.

[Pgcmoore]

Do the one from DiabloSport have the Nurled bottoms? I like the horns more than the BT engraving!