2001 DT 466 with an M1000 Powerpuck | no difference at all

TunerTools · Post by **TunerTools** » Tue Dec 14, 2010 10:48 pm

Hi guys,
I have a customer with a 2001 DT 466 International. With an M1000 connected, there is no measurable difference at all in the HP or the way it runs and this has been checked on a local dyno there. It's not throwing any MIL light, not running any worse, but it's not running any better either, in fact it's like nothing was even plugged in.

Have you ever seen this before? I have not. I have seen a couple where the connections were wrong or the Powerpuck defective, but those all threw a MIL light and went into limp mode. In this case, it's like nothing was even plugged in.

Please advise

Post by **mikel** » Wed Dec 15, 2010 11:03 am

Lloyd, in this case it sounds like the diablo dial may be the culprit.

When the dial is unplugged (or not working) the puck is simply a pass through device, which is what sounds like is happening here.

If you have anopther puck, please try swapping out the dial (simple plug in), and if that works, we'll simply get another dial out to you asap.

Let me know.

Thanks

TunerTools · Post by **TunerTools** » Wed Dec 15, 2010 9:43 pm

Hey Mike, there was some additional information he told me today that I didn't have before. It's definitely bad.
I'll email an RMA request in.

Post by **mikel** » Thu Dec 16, 2010 12:49 pm

Got it, thanks.

meetpeter · Post by **meetpeter** » Thu Jan 20, 2011 8:06 am

hey guys,
i am new in this forum and i like the concept.
i want "2001 DT 466 with an M1000 Powerpuck"
can you tell me how can i get it??????
thanks in advance!!!!!

Post by **mikel** » Thu Jan 20, 2011 11:52 am

Contact Lloyd at TunerTools

www.TunerTools.com

misterfruehling · Post by **misterfruehling** » Tue Jul 19, 2011 1:40 am

ive got two 2005 international 4300 .. dt466 ... i got two pucks , same trouble as first post, they have no efect on power what so ever on eather truck, tryed enterchanging the parts but no sucsess.

i ordered them on fri and got them today and they don't seem to work

my trucks are idetical shop trucks they wiegh 24000lbs right now they go up the steeper grades at 40mph with the pucks atached it does not change

Post by **mikel** » Tue Jul 19, 2011 9:25 am

No codes or issues, as if nothing happened?

misterfruehling · Post by **misterfruehling** » Tue Jul 19, 2011 9:28 am

yeah no codes , they just act like nothing has happened

Post by **mikel** » Tue Jul 19, 2011 9:30 am

Are you sure the MAP is connected at the middle and the Fuel at the end?

2001 DT 466 with an M1000 Powerpuck | no difference at all

2001 DT 466 with an M1000 Powerpuck | no difference at all

RE: 2001 DT 466 with an M1000 Powerpuck | no difference at a

RE: 2001 DT 466 with an M1000 Powerpuck | no difference at a

RE: 2001 DT 466 with an M1000 Powerpuck | no difference at a