Unable to update/calibrate *Please help ASAP*

RealtorRod · Post by **RealtorRod** » Mon Jul 25, 2016 7:37 pm

This first image is when it is attached to my PC and after it 'says' it has updated

20160725_161242.jpg

The second image is what the firmware says when I connect it to my vehicle

20160725_160700.jpg

This is when I try to flash my original file back

20160725_161059.jpg

The fourth is what it says when I try to adjust parameters or install a tune.

20160725_161151.jpg

I get this when I click okay above.

20160725_161223.jpg

Rinse and repeat

Post by **mikel** » Tue Jul 26, 2016 9:01 am

what vehicle?

please post the info.xml file from the intune drive.

RealtorRod · Post by **RealtorRod** » Tue Jul 26, 2016 1:17 pm

It is a 2014 Jeep GC 5.7L. I have attached the XML below.

info.xml

RealtorRod · Post by **RealtorRod** » Tue Jul 26, 2016 5:14 pm

Any luck?

Post by **mikel** » Wed Jul 27, 2016 10:24 am

what started this?

did you take the truck to a dealership and then try to tune it when you got it back?

RealtorRod · Post by **RealtorRod** » Wed Jul 27, 2016 3:29 pm

I took my vehicle in for the shifter tsb. I guess they may have done something. If so, how do I fix it?

Post by **mikel** » Wed Jul 27, 2016 3:41 pm

fax or email proof of the dealer flash to us then call with the tool powered up and we'll reset it.

RealtorRod · Post by **RealtorRod** » Wed Jul 27, 2016 4:37 pm

I will have to get them to send me a copy of what they did as it was a free service so I did not receive a receipt.

RealtorRod · Post by **RealtorRod** » Wed Jul 27, 2016 5:02 pm

see attached

FRIESEN.pdf

Unable to update/calibrate Please help ASAP