Dataviewer not responding to my analog inputs

jd40 · Post by **jd40** » Mon Mar 02, 2020 10:08 pm

I installed an AEM EUGO and the gauge works just fine but when using the diablo analog cable with my intune i3 the gauge doesn't move off the minimum setting (which is 8.5:1 AFR) I have the red wire to connected to the white and the black to the brown. Also the ground is grounded in the same spot as the gauge. I've tried both analog inputs 1 and 2 and tried all different wiring combinations with no success over the past 2 weeks and am getting very frustrated. Is my wiring wrong? Or is it a software issue.

Post by **mikel** » Tue Mar 03, 2020 10:41 am

load this to the root of the i3 drive and then try again please.

jd40 · Post by **jd40** » Tue Mar 03, 2020 10:45 pm

mikel wrote:load this to the root of the i3 drive and then try again please.

That fixed it, thank you

Post by **mikel** » Wed Mar 04, 2020 11:48 am

great, we'll get this rolled current asap.

Dataviewer not responding to my analog inputs

Dataviewer not responding to my analog inputs

Re: Dataviewer not responding to my analog inputs

Re: Dataviewer not responding to my analog inputs

Re: Dataviewer not responding to my analog inputs